Complete Home Filtration System & Housing

001
  1. Introduction
  2. Guidelines and Warning
  3. Positioning Your Filter
  4. Installation Procedure
  5. Typical Installation
  6. Replacement Guide
  7. Cartridge Installation / Replacement
  8. Notes
  9. Warranty
001
  1. Introduction
  2. Guidelines and Warning
  3. Positioning Your Filter
  4. Installation Procedure
  5. Typical Installation
  6. Replacement Guide
  7. Cartridge Installation / Replacement
  8. Notes
  9. Warranty
1.Introduction

Thank you for purchasing a Complete Home Filtration System. Your system is a proven performer manufactured from only quality materials and components and will give years of ‘spring fresh’ water free of impurities if maintained properly.

The system is designed for mains or rainwater supply but can be used in other situations. For other types of water supply please contact our Customer Service Helpline.

Complete Home Filtration filter systems cartridges need replacing regularly to maintain optimum performance. This is a simple procedure when following instructions.

For cartridge replacements contact Customer Service.
Customer Service Helpline 1300 693 457

2. Guidelines and Warnings
  • Where line pressure exceeds 520 kPa, a pressure limiting valve must be installed. Protect the housing from water hammer.
  • Use on cold water line only (with water up to 52°C). For installation over 52°C please enquire as to a suitable housing. Protect the housing from freezing.
  • Avoid installing in direct sunlight where possible unless cover is included.
  • USE LOCTITE 55 AS YOUR THREAD SEALANT, use of any other thread sealant will void warranty. DO NOT use anaerobic sealants that dry hard e.g., Loxeal, use of anaerobic sealants will void the warranty.
  • Do not overtighten. Too much tape or over tightening may cause head to split.
  • For point of entry installations an approved dual check backflow prevention device must be fitted in accordance with national plumbing product codes.
  • Do not use with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection.
  • This product must be installed in accordance with local plumbing regulations by a licensed plumber.
  • Flush system for 5 minutes or more after any extended period of non-use.

Installation Note: A water filter system/tap, like any product, has a limited life and may eventually fail. Also sometimes failure happens early due to unforeseen circumstances. To avoid possible property damage, this product should be regularly examined for leakage and/or deterioration and replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used in those applications where any leakage could cause property damage, and damage, and/or the water supply should be turned off if no one is home/present.

INSTALLATION MUST BE COMPLETED BY A LICENCED PLUMBER. FAULTY OPERATION DUE TO UNQUALIFIED PERSONS WILL RESULT IN VOIDED WARRANTY COVERAGE.

2. Positioning Your Filter

Choose a location where any water spillage will not cause damage. Make sure mounting position is solid so that the filter housing stays in position when changing filters. An isolation valve may be installed immediately prior to the filter to isolate the filter for changing the cartridge.

linedrawing copy 1